Stack on safe electronic lock zip#
- Once the control board is out of the hopper, you may have to cut a tiny zip tie and remove the top of the fuse box.You can reach up into the bottom of the hopper and press firmly on these tabs and push the control board out of the front of the hopper. There are usually three tabs on the top of the control board and three on the bottom (on the back). - If your control board does not have screws on the front, it will have tiny plastic tabs on the back of it that need to be compressed for the control board to pop out the front of the hopper.- If your control board has two screws on the front of it, remove them, then take the control board out the front of the hopper or feed it back inside the hopper and out the bottom of the hopper.Follow these directions to check the fuse: The fuse is on the back of the control board in a little green box. - Plug in the unit and turn it on to see if that resolved the issue.- With the hopper access panel removed, disconnect and then reconnect the power connection wires (black/white).Check the power connection on the back of the control board. If the cord is damaged, then you can contact our Pit Boss Customer Care Team for further assistance. - Inspect the power cord for visible damage that could be causing the issue.Try the grill in another outlet, or something else in this outlet to ensure that is not the issue. Check the outlet the grill is plugged into to make sure that it is working properly. There are several screws that hold this panel in place). To access the areas needed to troubleshoot for power, you will also need to remove the hopper access panel from the bottom of the hopper. (Please make sure when you are working on your grill that it is not plugged into power. There are several reasons why your grill may not be powering on. Why does the fan continue to run after I turn my Pit Boss grill off? Even with priming, once the pellets reach the fire pot, your grill may need to be turned off and then back on again, to restart the igniter for the first several minutes now that the auger is loaded with pellets.
(Holding the Prime button does not cause the auger to turn faster). Holding the Prime button prevents the auger from pausing, so the pellets arrive more quickly. - Usually, it takes longer than this for the pellets to travel from the hopper to the firepot on the first use.- The igniter stays hot for the first several minutes after powering the grill on and then shuts itself off.If your grill has never been used or has run completely out of pellets, it will need to be Primed to get pellets to the fire pot while the igniter is still hot. Many of our Pit Boss grills have a Prime Button. - Once your grill reaches the desired cooking temperature, then food can be added to the grill.- Leaving the lid open prevents overloading the barrel with smoke and helps prevent a backdraft in the unit.- Starting the grill on the smoke setting ensures that the firepot is not overloaded with pellets.Then close the lid and adjust your temperature to the desired setpoint. Start the grill with the lid open on the smoke setting for 10 minutes.
0 kommentar(er)
